ZEISS
BEDIENUNG
Stativ M LED
6
435425-7144-008
06/2016
D
eu
tsch
•
Anschließend durch Drehen des Knopfes den Kippwinkel des Drehspiegels verändern, bis die
Objektstrukturen hell vor dunklem Hintergrund leuchten.
Durch Verschieben des Dreh-/Schiebeknopfes (Bild 5/
3
) in eine mittlere Position (RC) und
zusätzliches Kippen des Spiegels wird eine Schräglichtbeleuchtung erzeugt, die Strukturen
ungefärbter Objekte im Reliefkontrast sichtbar macht.
Durch Drücken/Drehen des oberen Beleuchtungsknopfes
1
)
kann dem eingestellten
Durchlicht variabel Auflicht hinzugemischt werden.
Detaillierte Informationen zur Bedienung der optionalen Auflichtbeleuchtungen K LED ent-
nehmen Sie der Bedienungsanleitung Stemi 305/508.
4.3
Bedienung der Speichertasten
Das Stativ M LED besitzt drei Speichertasten
(Bild 6/
1
), um verschiedene Beleuchtungs-
zustände zu hinterlegen und ein schnelles
Umschalten zwischen den verschiedenen
Auflicht, Durchlicht-
und Mischlicht-
beleuchtungen zu ermöglichen.
Um einen Beleuchtungszustand zu speichern, wie
folgt vorgehen:
•
Die gewünschten Beleuchtungen (Auflicht
und / oder Durchlicht) durch Drücken des
oberen Drehknopfes (Bild 6/
2
) bzw. unteren
Drehknopfes (Bild 6/
3
) einschalten.
•
Die Beleuchtungsintensität des Auflichts /
Durchlichts durch Drehen des oberen
Drehknopfes (Bild 6/
2
) bzw. des unteren
Drehknopfes (Bild 6/
3
) einstellen.
•
Die gewünschte Speichertaste (Bild 6/
1
) für 3 Sekunden gedrückt halten. Alle 3 Tasten leuchten auf,
wenn der Speichervorgang abgeschlossen ist.
•
Bei der Belegung der anderen beiden Speichertasten analog verfahren.
•
Um einen gespeicherten Beleuchtungszustand wieder aufzurufen, die gewünschte Speichertaste
kurz drücken.
Der Einschaltzustand (An / Aus) sowie die Helligkeit aller adaptierten Beleuchtungen werden
abgespeichert. Ausnahme: Bei der Ringleuchte K LED wird nur der Einschaltzustand (An /
Aus) gespeichert. Helligkeit sowie Segmenteinstellungen der Ringleuchte werden nicht
gespeichert und bleiben daher beim Aufrufen der Speichertasten M1-M3 unverändert.
Factory Reset: Bei ausgeschaltetem Stativ M LED alle drei Speichertasten M1-M3 gleichzeitig
drücken und das Stativ währenddessen einschalten. Die Speicher M1 / 2 / 3 werden geleert
und alle angeschlossenen Beleuchtungen werden mit 50 % Helligkeit eingeschaltet.
Kurzzeitiges Drücken der Tasten M1-M3 bewirkt nun bis zur erneuten Speicherung keine
Beleuchtungsänderung.
Bild 6
Speichertasten bedienen