![background image](http://html1.mh-extra.com/html/zeiss/photoscope-85-t-fl-series/photoscope-85-t-fl-series_instructions-for-use-manual_927761014.webp)
Preparation
14
Inserting/removing the batteries
Press the compartment release button (Fig. 1/9) to open the rain and dust-proof battery
compartment. When inserted, the battery contacts must point to the left.
Insert the battery on the right side of the battery compartment then push it to the left, in
the direction of the arrow (on the battery) until it clicks into place.
Insert the two enclosed batteries of type
LR 03 (Micro AAA) into the remote control.
Ensure the correct polarity for each, accord-
ing to the symbols in the battery compart-
ment. The enclosed carry cord can be fixed
to the eyelet on the bottom end of the
remote control.
Remove the batteries if the PhotoScope is to
remain unused for an extended period.
Mains operation
The mains unit of the battery charger also allows the PhotoScope to be operated directly
from the mains. To do this, connect the mains unit to the DC input (Fig. 1/15) on the
PhotoScope, which is located under the battery compartment cover.
The DC input plug can also be connected from outside with the battery compartment cover
closed. To do this, carefully press out the round seal plug (Fig. 1/10) in the battery com-
partment from inside.
After using the mains unit, the seal plug must be replaced in the battery compartment
cover. Only then is protection against dust and damp guaranteed.
Note:
The date and time settings are retained when the batteries are changed.
However, if the battery is removed for an extended period, the time setting is deleted.
In this case, reset the date and time.