Setting up the workpiece
6-14
61211-1270302
MMZ M
Fastening the workpiece on the measuring plate
Workpieces must always be clamped in order to prevent them from be-
ing moved, knocked over or falling down from the measuring plate. Any
workpieces that have not been clamped endanger the personnel, the
CMM and the workpiece.
CAUTION
Risk of injury if an unfastened workpiece falls down.
Crushing and severing body parts.
Clamp the workpiece on the measuring plate before measuring the
workpiece.
Precautionary measures
Certain safety measures have to be observed to avoid damage to the
CMM and the measuring plate.
1
Do not exceed the permissible workpiece weight. See Technical
specifications.
2
Carefully put the workpiece down on the measuring plate.
3
Never place the workpiece on the guideway.
The function of the bearings could otherwise be adversely affected.
4
Lift and move heavy workpieces with a lifting device.
Approach the CMM slowly in order to avoid damage to the
CMM.
Make sure that the workpiece or lifting device does not strike the
CMM. Even light jolts may affect the functioning of the CMM.
Lower workpieces more than 15 kg in weight to the measuring
plate at a maximum speed of 2 mm/s. The CMM may be dam-
aged if the workpiece is set down hard.
5
Put the workpiece down vertically on the measuring plate.
6
Do not move the workpiece on the measuring plate.
Summary of Contents for MMZ M
