16
Changing the lamp cable (optional)
AURA
®
handheld NIR - Rev. 2
Maintenance and Repair Manual | AURA
®
handheld NIR - Rev. 2 | EN_40_070_0030I
5 Changing the lamp cable (optional)
The following steps should only be performed if required.
Scheduled regular replacement of the lamp cable is not required.
•
The display has been removed (see section “3 Changing the display” on page 8)
•
The front plate
1
has been removed
(see section “6 Changing the motor”, steps 1 to 2)
•
The lamp holder
2
has been disassembled
(see section “4 Replacing the halogen lamp”)
•
Put the following spare parts ready:
– lamp cable, order no. 000000-2224-159
1
Disconnect the lamp cable from the halogen lamp
Disconnect the lamp cable from the halogen lamp
3
.
At the narrow points (see red dotted ellipse in the figure below), take special
care to avoid damaging the electronic components (or the new lamp cable
during installation).
Fig. 10
4
3
2
1
Disconnect the lamp cable from the halogen lamp
Requirements
Procedure
