Safety considerations
All fastening devices must be
designed to mechanically hold
the assembly in place without
the ability to loosen or break
away due to system operation or
vibration.
Never pressurize equipment
beyond specified pressures.
Always pressure test with an
inert fluid such as water or
dry nitrogen to avoid possible
damage or injury in the event of a
leak or component failure during
testing.
Always protect adjacent
flammable material when welding
or soldering. Use a suitable heat
shield material to contain sparks
or drops of solder. Have a fire
extinguisher readily available.
Please follow standard safe
practices regarding the handling,
installing or servicing of
mechanical equipment.
Read these instructions
thoroughly and follow all
warnings or cautions attached
to the equipment. Consult
local building codes for special
installation requirements.
Understand the signal words:
danger, warning and caution.
Identifies the most serious
hazards which will result in
severe personal injury or death.
Signifies hazards that could
result in personal injury or death.
Used to identify unsafe
practices, which would result in
minor personal injury or product
and property damage.
The installation of Rittling
Cabinet Convectors and all
associated components, parts
and accessories which make
up the installation, shall be in
accordance with the regulations
of all authorities having
jurisdiction and must conform to
all applicable codes. Only trained
and qualified service personnel
using good judgment and safe
practices should install, repair
and/or service air conditioning
equipment.
Untrained personnel can perform
basic maintenance functions
such as cleaning coils. All other
operations should be performed
by trained service personnel.
When working on air conditioning
equipment, observe precautions
in the literature, tags and labels
attached to the equipment and
all other safety precautions that
may apply.
Improper installation,
adjustment, alteration, service,
maintenance, or use can cause
hazardous conditions which
may cause serious personal
injury and/or property damage.
Consult a qualified installer,
service agency, or your sales
representative for information or
assistance.
The equipment must always be
properly supported by rigging and
lifting equipment. Any temporary
supports used during installation
or maintenance must be designed
to adequately hold the equipment
in place until equipment is
permanently fastened and set
in its final location. All supports
must meet applicable local codes
and ordinances.
The manufacturer assumes
no responsibility for personal
injury or property damage
resulting from improper or unsafe
practices during the handling,
installation, service or operation
of the equipment. The installation
of cabinet convectors and all
associated components, parts
and accessories shall be in
accordance with the regulations
of all authorities having
jurisdiction and must conform
to all applicable codes. It is the
responsibility of the installing
contractor to determine and
comply with all applicable codes
and regulations.
10
