Safety
Read all the safety information carefully before you use
the ComfoAir Q for the first time to make sure that you
use it safely and correctly. Refer to the full manual for the
necessary information and the applicable safety regulations
and installation regulations.
WARNING
Electricity hazard
Safety instructions – general
Always obey the safety regulations,
warnings, comments and instructions
in this quick guide. If you do not obey
them, personal injury or damage to the
ComfoAir Q can occur.
Installation, commissioning and
maintenance must be carried out by
a certified installer unless instructed
differently. A non-certified installer can
cause personal injury or damage the
performance of the ventilation system
After installation, all parts that can cause
personal injury are safely contained
within the casing. Tools are required to
open the casing.
Do not open the casing. The installer
makes sure that all parts that can cause
personal injury are safely contained
within the casing.
Do not disconnect the power to the
ComfoAir Q, unless instructed otherwise
in the ComfoAir Q manual. This can lead
to a build-up of moisture and result in
problems with mould.
Do not change the ComfoAir Q or the
specifications given in this document.
Changes can cause personal injury
or damage the performance of the
ventilation system.
Safety instructions – maintenance
Make sure that no units are used with
exposed fire (fireplace or stove). The
ComfoAir Q can pull the smoke or gases
from the fire into the house.
Get a (maintenance) engineer to inspect
and clean the ComfoAir Q at least
every two years to make sure that the
performance of the ventilation system
will not decrease.
Replace the filters at least every
six months to keep the indoor air
comfortable, healthy and the ComfoAir Q
clean.
Clean all valves and grilles at least
every six months to make sure that the
capacity of the ventilation system will
not decrease.
Safety instructions – installation
Always obey the general and locally
applicable construction, safety and
installation regulations.
Install the ComfoAir Q in a frost-free
space (minimum 4°C to 5°C) to prevent
the condensation drain from freezing.
Remove the unit plug from the wall
outlet to disconnect the unit from the
power supply. If the unit does not have
a plug, use a switch as specified in EN
60335-1 (with switch-off of all poles and
3 mm overvoltage category III).
Always disconnect the power to the
ComfoAir Q before working on the
ventilation system. When the ComfoAir
Q is open while in operation, it can
cause personal injury. Make sure that
the ComfoAir Q cannot be set to ON
accidentally.
Always connect air ducts of at least
900 mm to the ComfoAir Q before you
connect the unit to the power supply
to make sure that you cannot touch
the motor while the ComfoAir Q is in
operation.
Always take ESD protective measures
when you work with electronics, such as
wearing an antistatic wristband. Static
electricity can cause damage to the
electronics.
Connect the ComfoAir Q to a 230 V-50
Hz power supply. Any other power
supply will damage the ComfoAir Q.
Zehnder Group Zwolle B.V. • Lingenstraat 2 • 8028 PM Zwolle • NL Tel.: +31 (0)38-4296911
Commercial Register of Zwolle 05022293
2 - EN
