Zehnder Rittling ComfoAir 350 Luxe, User Manual

Page: 56 / 60

52 En
Time delay values
Sub-menu description Mini-
mum Maxi-
mum
General
Reset
P25
note:
Only applies to systems fit-
ted with an RF switch.
Overrun timer for ventilation setting 3 (using "
").
• After pressing " " briefly (< 2 sec.), the
ComfoAir will switch to the
high
setting for
‘x’ minutes and then automatically returns
to the
normal
setting.
If any 3-position switch is operated during this
lagging time the ComfoAir will instantly revert
to the ventilation position as set at that time.
1 Min. 20 Min. 10 Min.
P26
note:
Only applies to systems fit-
ted with an RF switch.
Overrun timer for ventilation setting 3 " using
".
• After pressing " "
continuouSly
(> 2 sec.),
the ComfoAir will switch to the
high
setting
for ‘x’ minutes and then automatically re-
turns to the
normal
setting.
If any 3-position switch is operated during this
lagging time the ComfoAir will instantly revert
to the ventilation position as set at that time.
1 Min. 120 Min. 30 Min.
P27
note:
Only applies to systems fit-
ted with a CC Ease panel or
CC Luxe panel.
Time for the Boost setting.
• After pressing "[ ]" on the CC Luxe
panel or after pressing “ ” continuosly
(>2 sec.) on the CC Ease panel, the Com-
foAir will switch to the high setting for 'x'
minutes and then automatically returns tot
the NORMAL setting
If any 3-position switch is operated during this
lagging time the ComfoAir will instantly revert
to the ventilation position as set at that time.
0 Min. 120 Min. 30 Min.
P29
(Optional)
Setting the extractor hood ventilation levels.
• When the extractor hood is switched on the
extractor hood ventilation settings can be
set x-% higher than the corresponding 'nor-
mal' ventilation levels.
1% 99% 10%
Menu P9
¨
Status of programmes (from menu P5 and P6 additional programmes)
Status
Sub-menu description Activated
P90 Open fire programme active? Yes (1) / No (0)
P91 Bypass Open? Yes (1) / No (0)
P92 Geothermal heat exchanger valve
Open?
Yes (1) / No (0)
P93 Afterheater on? Yes (1) / No (0)
P94 Analogue input (0-10V) active? Yes (1) / No (0)
P95 Frost protection or Preheater active? Yes (1) / No (0)
P96 Extractor hood on? Yes (1) / No (0)
P97 Enthalpy programme active? Yes (1) / No (0)