Zeegma Zonder Klaar, User Manual

Page: 11 / 76

EN
the filter refill. Make sure all pieces are dry before you put them into the
vacuum cleaner.
Important! Regularly wash filters and use a wet cloth to wipe the dust
sensor which is responsible for regulation of the flow in auto mode.
*Dust sensor is located in the hollow, under the dust bin (fig. 11).
Troubleshooting
Problem Cause Solution
The product does not
work
Storage battery is flat Charge the storage battery
Storage battery life is over Replace the storage battery
Damaged motor Contact the manufacturer
The vacuum cleaner has
no suction power or its
power is low
Filter in the device is clogged
up
Carefully wash the filter
under running water.
Precisely dry off before use
to make sure bacteria do not
grow
Dust bin is full Empty the dust bin
Dust bin is not properly
installed
Install the dust bin correctly
Replaceable roll is blocked Clean the replaceable roll
HEPA filter must be replaced Buy a new HEPA filter and
replace it very 6 months
The battery does not
charge
Poor contact between the
device and a docking station
Do not touch or move the
docking station as long as
you can see a charging light.
Change the charging
method, connect the device
straight to the charger
The charging light does
not glow
Storage battery stopped
working
Contact the manufacturer
The docking station is not
connected to power supply.
If the cable is connected to
power supply, make sure it is
not damaged
Air coming out of the
vacuum cleaner emits
an unpleasant odor
Filter is not clean Wash the filter and dry
the filter off before use to
prevent growth of bacteria or
replace the filter
During the first few cycles
of operation, the device may
emit a smell of plastic. It is
a normal phenomenon
The smell of plastic will
vanish after some time
The pictures are for reference only. The real design of the products may differ from the
pictures presented.