zebris Medical GmbH
FDM Technical Data and Operating Instructions
Page 18/36
If the WinFDM software is installed correctly then attach the power supply unit to a mains
outlet and the power socket of the interface box. In case it is necessary to use a mains
adapter make absolutely sure that it has ground contacts. This is necessary for your
measuring system to operate safely.
Finally connect the USB-socket by means of the USB-cable to the PC.
WARNUNG
Never use a USB-Hub or similar device to connect the platform
to the PC. Only by plugging the platform directly to a USB port
of the PC the functionality of the platform can be guaranteed.
zebris does not take any liability for any injury to persons,
damage to property, or loss of data due to improper connection
of the platform.
If the power supply unit and the USB cable are connected to the sockets of the platform,
please close the lid of the safety lock and fasten it to the housing by means of the four
screws supplied with the platform.
WARNING
Set all connection cables in a way that prevents patients, or
persons taking part in the measuring procedure from trip over
them. (If necessary anchor the cables with adhesive tape to the
floor.)
3.5 Setting the system out of operation
In order to set the system out of operation please close the WinFDM software first, then
exit the Windows operating system and shut down the PC. In the next step disconnect the
power supply unit of the FDM sensor and the treadmill from mains supply.
safety lock
