zebris Medical GmbH
FDM Technical Data and Operating Instructions
Page 28/54
4
Video-Module
4.1
SYNCCam
The
SYNCCam
is an accessory of the FDM-T system and perfectly adapted to be used in
combination with the force distribution measurement. All adjustments of the camera are car-
ried out via hardware setup integrated to the zebris FDM Software. The camera is connected
to the PC by a USB cable of type A-B included within the shipment.
The camera is equipped with ¼ inch tripod threads and can be adapted to zebris tripods as
wells as commercially available camera tripods.
WARNING
The Sync-LEDs are flashing when the camera is disconnected from
the USB port. Therefore it is strongly advised not to look directly into
the camera when it is disconnected in order to avoid dazzling.
Technical Specifications
REF-No.
01540190
Dimensions
110 x 125 x 15mm (L x W x H)
Weight
approx. 190g
Power Supply
USB (5V DC / 500mA)
Resolution
1920 x 1080 Pixel (Full-HD) / Autofocus
Frame Rate
30Hz
Synchronization
LED-Flash triggered by Sync-IN socket
Mounting
¼ Inch tripod-thread at bottom and back side
NOTE
In order to maintain undisturbed transmission of the video signal it is
mandatory to use high quality USB cables.
Please, only use cables supplied or recommended by zebris for con-
necting SYNCCam and PC.
USB Socket Typ B
Flash LED‘s
Status-LED
Sync-out
Socket
Sync-in Socket
¼ Inch Tri-
pod-Thread
