Zebex ZB-2200AM SERIES, User Manual

Page: 5 / 25

3. DEFAULT PARAMETERS
This table gives the default settings of all the
programmable parameters. The default settings
will be restored whenever the "Reset"
programming label is scanned and the CCD
scanner is in programming mode.
DEFAULT VALUES OF OPERATING
PARAMETERS
Function Default Values
Scanning Mode Selection Trigger mode
Header and trailer None
Inter-Message delay Normal
Inter-Character delay Normal
Message/Block mode selection Message
Send command in block mode
communication Disable
Good read beeper tone selection 2KHz/120
mSec
Code identifier transmmiting Disable
Code 39 bar code identifier code M
ITF 2 of 5 bar code identifier code I
Chinese post code identifier code H
UPC-E bar code identifier code E
UPC-A bar code identifier code A
EAN-13 bar code identifier code F
EAN-8 bar code identifier code FF
Codabar bar code identifier code N
Code 128 bar code identifier code K
Code 93 bar code identifier code L
MSI bar code identifier code P
MATRIX 25 bar code identifier code G
2
DEFAULT VALUES OF KEYBOARD EMULATION
PARAMETERS SETTING
Function Default Values
Keyboard type selection IBM PC/AT USA
Message terminator Enter/ carriage
return
DEFAULT VALUES OF RS-232C SERIAL
COMMUNICATION PARAMETERS
Function Default Values
Handshaking protocol None
ACK/NAK response time
setting 300 msec
Baud rate 9600
Data bit 8
Stop bit 1
Parity Mark (None)
Message terminator
selection CR/LF
DEFAULT VALUES OF WAND EMULATION
PARAMETERS
Function Default Values
¡ °
Wand emulation speed Normal
¡ ° Wand emulation output Black = High
Note: For wand emulation, the configuration is
only effective for the items with asterisk (
¡ °
).
3