Zebex Z-6170, User Manual

Page: 14 / 28

6.4 Verifying Scanner Operation
Please follow the procedure below to verify scanning operation.
1. Insert the modular plug of the Interface cable into the back of the scanner
until a firm click is heard.
2. If necessary, plug the power adapter into the jack on the interface cable.
3. Plug the AC end of the power adapter into an AC outlet, or plug the other end
of cable into host if power adapter is not needed. When power is supplied,
the scanner powers up, the speaker sounds four beeps and the LED
indicator glows.
4. Present a known-good test barcode to the scanner. The scanner should
issue a short beep and the LED should flash red momentarily.
1. If the scanner is connected to a USB for this test, it should
read one barcode, beep and then remain a red LED
indicating light. This is normal when the USB is not
connected to a live host terminal. If the initial interface of
the scanner is in keyboard wedge, and it only reads one
barcode and remains with a green LED indicating light, this
is because the scanner is not connected to a host terminal.
2. If the scanner does not produce any beeps, or produces
the wrong beeps, or the LED does not light up, remove the
power connection and refer to the Troubleshooting section
on pg 8.
9