Zebex Z-3052, User Manual

Page: 159 / 192

152
FN1 Substitution Values
The Wedge and USB HID Keyboard hosts support a FN1 Substitution feature.
When enabled any FN1 character (0x1b) in an EAN128 bar code is substituted
with a value. This value defaults to 7013 (Enter Key).
When using host commands to set the FN1 substitution value, set the key
category parameter to 1, then set the 3-digit keystroke value. See the ASCII
Character Set table for the currently installed host interface for the desired
value.
To select a FN1 substitution value via bar code menus:
1. Scan the bar code below.
Set FN1 Substitution Value
2. Look up the keystroke desired for FN1 Substitution in the ASCII
Character Set table for the currently installed host interface. Enter the
4-digit ASCII Value by scanning each digit in
Appendix D, Numeric Bar
Codes .
To correct an error or change the selection, scan Cancel. To enable FN1
substitution for USB HID keyboard, scan the Enable FN1 Substitution barcode.
Transmit “No Read” Message
Scan a bar code below to select whether or not to transmit a No Read
message. When enabled, the characters NR are transmitted when a bar code
is not decoded. When disabled, if a symbol does not decode, nothing is sent to
the host.
Enable No Read
Disable No Read