29
Configure the AC+Thin AP mode
The ZAC Access Point provides 4 operation modes:
“
Thin AP
”, “
Virtual AC
”, “V
irtual AC+Thin AP
”, as
well as
“
FAT AP
”. The default mode is “Thin AP”. To allow the ZAC Access Point to manage the thin
APs, you need to switch one of the ZAC Access Points to virtual controller mode first. To change the
mode, please do the following.
Configure the AC+Thin AP mode
To operate as AC+Thin AP, go to
Basic Settings
. From
Device Mode
drop-down list, select
“
Virtual
AC
” mode. If you would like the Access Point to perform as a virtual controller and access point
concurrently, please select
“
Virtual AC + Thin AP
” mode. Then assign an IP address to the ZAC
Access Point and specify subnet mask, gateway and DNS address respectively. Hit
Apply
and wait for
about 50 seconds to take effect.
AC+ Thin AP mode allows the ZAC Access Point to operate as access controller and thin
AP concurrently.
To operate as standalone Access Point, wireless client or bridge, please select
FAT AP
from device mode.
Note:
Note:
