Solo documento principale.
62/67
Identification: MD-AL-GI-00
Rev. 1.2 07.06.21 - Application: GID
Connext User Manual
Rev. 2.2 10/01/2023
Figure 68 - Password setting, Mode of Use and Power configuration screen
4)
T
o set the mode of use, select ‘Set Mode’ from the screen shown in the Figure, two screens (
69 -a and Figure 69 -b) will open in sequence within a few seconds of each other. Wait until the
screen in Figure 69 -b appears, then proceed to select the working mode
Figure 69 - Screen for setting working mode
5)
Select the desired working mode, i.e.
Plug&Play
–
just plug in the car to automatically start
the charging cycle. Wait 120 sec for the setting to become active, then switch the device off
and on again.
Using RFID cards
After completing the system configuration on the app, you can configure the wallbox to use RFID
cards.
1)
In the screen shown in Figure 68
, select the “Offline” working mode and press Confirm/Start.
Wait 120 sec for the setting to become active, then switch the device off and on again.
2)
From the screen in Figure 68
, select item ‘3. Management’ and press Confirm/Enter. Wait for the
page in Figure 70 to appear.
Set PWD
Set Mode
Set Current
(a)
(b)
Mode: Online
Clear log after mode change
1. Online
2. Offline
3. Plug&Play
