49
Figure 20 Access Control
Profile Selection
Select the VAP profile you would like to enable Access Control
Access Control Mode
If you select “
Allow Listed
”, only those clients whose wireless MAC addresses are in the access
control list will be able to connect to your AP. While when “
Deny Listed
” is selected, those
wireless clients on the list will not be able to connect the AP.
MAC Address
Enter the MAC address of the wireless client that you would like to list into the access control list,
click “
Apply
” then it will be added into the table at the bottom.
Delete/Clear
Check the box before one or more MAC addresses of wireless client(s) that you would like to
cancel, and click “
Delete
” or “
Clear
” to cancel that access control rule.
WDS Settings
Bridge mode extends the range of your network without having to use cables to link the Access Points
by using the Wireless Distribution System (WDS): Simply put, you can link the Access Points
wirelessly. To enable Bridge mode, please go to
Wireless
>
Basic Settings
and choose “Bridge” in
Operation Mode
. Then go to “
WDS Settings
” in “
Wireless
” as below:
