31
Figure 6 Network Settings
Network Mode
:
Specify the network mode, including Bridge and Router. It is easy to configure parameters in
Bridge Mode; however, users must pay extra attention to the way they configure the device when
it is set to Router Mode. For details, please refer to
TCP/IP Settings”
.
Spanning Tree
:
Spanning Tree Protocol (STP) is a link management protocol for AP which provides path
redundancy while preventing loops in a network. STP allows only one active path at a time
between the Access Points but establish the redundant link as a backup if the initial link fails.
STP Forward Delay
:
STP Forward Delay is the time spent in detecting and learning network tree topology state before
entering the forward state. Default time value is 1 sec.
802.1Q VLAN:
To allow users on the VLAN to access the WEB page of the
IEEE 802.11n Wireless Access Point,
you need to enable “
Enable 802.1Q VLAN
” and assign a management VLAN ID for your device.
Make sure the assigned management VLAN ID is identical to your network VLAN ID to avoid
failures of accessing the Web page of the IEEE 802.11n Wireless Access Point.
IP Address Assignment
