Quick Start Guide
CPE
4
e. Software
CD
f. This
Guide
g. Mast-mount
Hardware:
i. Brackets x 2
ii. Clamps x 2
iii. Screws x 4
iv. Washers x 8
v. Nuts x 4
* WARNING:
Items “b”, “c” and “d” are for indoor-use
only.
2. Prepare
For
Installation.
The following tools and items are required for
installing the product.
a. A flat-heat screw driver
b. A drill
c. A wall feed-thru tube
d. An
antenna
mast*
* Note: The product is designed to be mast-
mounted. Alternatively, the product may be
wall mounted (hardware not included).
3. Gather Basic Information.
Gather the following information and write it in
the space provided for future reference. Enter
“NA” for not applicable. Refer to end of this
Guide for sample configurations.
a. Password: __default______________
b. ESSID:
_____________________
c. IP
Address: _____________________
d. Netmask:
_____________________
e. Gateway:
_____________________
f.
Enable DHCP client:
YES ___ NO ___
g. Enable Internal Router: YES ___ NO ___
h. Internal Router’s WAN Port on:
WLAN _____ Ethernet ____
i. NAT:
YES
_______ NO_________
j.
Internal Router’s LAN port IP address:
_______________________
k. Internal Router’s LAN port Netmask:
_______________________
l.
Enable Internal DHCP server:
YES ________ NO ________
Begin IP_________________
End IP__________________
Netmask________________
Gateway________________
Primary DNS_____________
Secondary DNS___________
Primary WINS ____________
Secondary WINS _________
m. WEP Key: _______________________
4. Install
Software.
Install the software on a PC connected to the
same Ethernet segment as the product.
a. Insert the CD into your CD-ROM drive.
Run SETUP.EXE from the CD's root
directory.
b. Follow the on-screen prompts to install
the software on to your system.
5. Connect
All
Cables.
Connect cables as follows:
a. Insert the Category-5 cable to the Power
Injector port marked "NETWORK". Insert
the other end of the cable to an Ethernet
hub.
b. Insert the CPE-250HP's RJ-45 connector
to the Power Injector port marked "CPE".
c. Insert the AC adaptor connector to the
Power Injector port marked "DC In". Insert
the AC adaptor to a wall AC outlet. The
Power LED on the CPE-250HP should
turn on.
6. Configure
Product.
On a PC that is attached to the same Ethernet
segment as the CPE-250HP, run the installed
CPE-250 Manager software to configure the
product.
a. On the Windows desktop, click on
START|PROGRAMS|ZCOMAX CPE-250
MANAGER/CPE-250 MANAGER
to start the
software.
b. Once started, the CPE-250 Manager will
browse the Ethernet segment to locate
any attached CPE-250HP Series
products. It will display all CPE-250HP
units that it can locate during this
discovery process. Each CPE-250HP unit
is displayed in the form of an icon with its
default name listed below. This default
name is formed by concatenating "AP"
with the last 6 numbers of the CPE-
250HP's MAC address (example:
AP123456).
c. Double click on the CPE-250HP product
you wish to configure.
d. Enter “default” at the password prompt.
e. Once logged into the CPE-250HP, the
software will display the main screen.
Click on the tab labeled "
CONFIGURATION
".
f. The
CONFIGURATION
screen is now
displayed. Click on the tab labeled "
IEEE
802.11
".
g. The
IEEE 802.11
screen is now displayed.
