AS220V2
2x2 Dual Band 802.11ac Wave 2 Indoor Access Point
User Manual
Page 8
Safety Notice
3.4.
1.
Do not install the device close to any electrical grounding device or lightning protection
system. Place the device’s own grounding and lightning protection system apart from any
electrical grounding device and lightning protection system as far as possible.
2.
Protect components from electrostatic discharge: Please wear an ESD wrist strap or handle the
power adapter by its edge and do not touch any component or printed circuit boards,
especially for module device.
3.
Make sure to keep the temperature and humidity of the installation location at an optimal
level.
4.
An excellent grounding system guarantees the stable operation of device, as well as to protect
device from lightning, interference and electrostatic discharges.
5.
If installed outdoors, the device may be damaged by lightning. We recommend that you install
additional lightning protection devices if necessary, considering the conditions in your area.
6.
Supply stable power to the device. Unstable power may cause the device to malfunction. The
device supports PoE power supply and is recommended if the device is installed near grid lines
within less than 100 meters radius.
Powering the Access Point
3.5.
By WAN/PoE
Connect the PoE cable into the WAN/PoE IN
port of the device.
By a power adapter
(Optional accessory_
AC-48052)
Connect the power adaptor into the DC port of
the device.
Note:
It's available to turn on the access point by either
or
.
Note:
Please wait for 5-10 seconds while powering on.
Note:
LAN port provides DC 48V, Max. 208mA, and up to 10W power supply. The positive
side of the 48V is connected to pin 4 and 5, the negative side is connected to pin 7 and 8
for PoE-out.
Note:
Do
NOT
attempt to connect any
non
-PoE devices to LAN port and make sure the
input power of devices should comply with PoE-out standard.
Summary of Contents for AS220V2
Page 1: ......
