Zaxcom ZMT4 Flex Transmit Menu
10
TRANSMIT MENU
UHF Transmitter Power Level Set
The UHF transmit power of the ZMT4 Flex is set from this page. The transmit power can be adjusted to
output 25, 50 or 75mW. The higher the power setting the more battery power will be required.
UHF Transmit Modulation Set
The UHF transmission modulation is the way the ZMT4 Flex sends audio to the receiver. The modulation format
is set from this menu. Please note if the transmission format that is set here, and the format set on the receiver
do not match, the receiver will be unable to decode the audio from the transmitter. Also note that after any
change to the transmit format the ZMT4 Flex will need to be rebooted by pressing the card key before the new
format takes effect.
MONO
STEREO
XR
ZHD 96
ZHD 48
Modulation Bandwidth
200 kHz
196 kHz
200 kHz
96 kHz
48 kHz
Minimum Channel to Channel Spacing
400 kHz
200 kHz
400 kHz
300 kHz
200 kHz
6 MHz TV Channel Capacity
15
30
15
30
60
Latency
3.5ms
6ms
6ms
6ms
18ms
Compatibility with a 200 Series Receiver
2 Transmitters
2 Transmitters
2 Transmitters
2 Transmitters
1 Transmitter
Transmitter Disable - Record only mode
•
Record Only Mode
- Will set the ZMT4 Flex to act as a standalone recorder and will not transmit any audio
over UHF. This will conserve battery power since the transmitter is disabled.
•
Normal TX Mode
- Will allow the ZMT4 Flex to both transmit audio and record on its internal micro SD card.
TX FORMAT:
ZHD96
PRESS CARD TO REBOOT
TX DISABLE :
NORMAL TX MODE
TX POWER: 50MW
