Zaxcom QRX212, User Manual

Page: 14 / 22

Zaxcom RX12 System Menu
14
Recall Factory Defaults
From this menu the RX12 can be reset to the factory default setting.
ZaxNet Frequency Control
When enabled the RX12 will send frequency and gain change commands, via ZaxNet to the corresponding
TRX transmitter when the gain or receiver frequency is changed.
Serial Port Mode
When the ZaxNet frequency control is turned on the RX12 can communicate frequency and gain changes to
the TRX transmitters via the serial port on the RX12. The serial port will need to be plugged into the serial
port of a Nomad with ZaxNet IFB, an IFB200, TRX900CL, or a QRX with the QIFB option. Please note the
Nomad will need to be running software version 7.24 or higher, the IFB200 / TRX900CL will need to be
running software version 1.77 or higher, the QRX will need to be running software version 3.55 or higher.
How to send remote commands
Using an IFB200 or TRX900CL
In the extended menu:

Set the RS232 MODE to AUDIO INPUT.

Set the PHASE INVERT CH2 to OFF.

Set the AUDIO INPUT to ANALOG.
Using an QRX with QIFB
In the extended menu:

Set the SERIAL PORT MODE to ZAXLAN.
Using a Nomad with ZaxNet IFB
In the mode menu:

GP REMOTE ROLL needs to be OFF.
In the TRX transmitter (running software version 9.02 or higher)
In the extended menu:

Set IFB MODE to RX.

Set the IFB RX FREQ to match the IFB TX FREQ on the IFB / CL / QRX / Nomad.

Set the group code to match the group code on the IFB / CL / QRX / Nomad.

Set the unit code matches the unit code on the RX12 receiver configure menu.
Advanced Set up
Burn Boot loader
The boot loader is part of the software that helps boot up RX12. Generally, the boot loader will not need to
update. If the boot loader needs to be updated there will be a note released with the software to do so.
The boot loader software is already contained within the RX12 software.
Debug Bits
The debug bits are a factory diagnostic setting and should stay set to 0
.
Allow Logging
Allow logging will turn on the logging feature which will allow the RX12 to log warning and error messages
which then can be used by the factory to diagnose the RX12. The logged messages are displayed on the log
screen. If logging is not turned on, and an error occurs the RX12 will not log the errors.
Log Screen
This is where the RX12 displays the logged errors and warnings.