Zass ZTWD 12E B, Operating Instructions Manual

Page: 5 / 16

5. STORAGE AND SERVICE
6. WARNINGS
- If the appliance is not used for a long time, turn off both cold and hot water switches.
- Disconnect the appliance from the power source by unplugging the plug.
- Drain the water from the appliance through the 2 taps.
- Drain the remaining water through the drain plug behind the appliance.
- Press the hot water tap, air bubbles will be created in the water can, indicating that the water will
flow into the hot water and cold water tanks. Press and hold the hot water tap for as long as the water
will flow to the hot water tap.
- Do not connect the appliance to the mains until water is flowing to the hot water tap.
- Turn on the water heater switch, the red LED will indicate the operation of the heating system.
When the hot water temperature reaches 85-95 ° C, the red LED will turn off and the water heater will
turn off. The appliance goes into the state of maintaining the hot water temperature and when the hot
water temperature drops below 80 ° C, the water heating system will restart.
- Switch on the water cooling switch, the green LED will indicate the operation of the cooling system.
- The temperature of the cool water is directly influenced by the ambient temperature.
- Do not use cracked, cracked, drilled or damaged water cans.
- Place the appliance in a shady, cool place away from the wall or hot items.
- Place the appliance away from appliances, electronic equipment or valuables.
-
To prevent damage to the water heater resistance, do NOT turn on the water heater switch
until the water starts to flow on the hot water tap.
- DO NOT allow children to use the appliance to prevent hot water burns.
- DO NOT turn on the water heater switch if there is no water in the appliance.
- DO NOT tilt the machine more than 30 degrees during handling.
As the cold water temperature drops by 5-15 ° C, the green LED will go out and the water cooling
will stop. The appliance goes into the state of maintaining the cool water temperature and when the cold
water temperature rises above a set value, the water cooling system will restart.
- Since the temperature of the cold water has been set at the factory, no further adjustments are
necessary.
- If you switch on both water heating and cooling switches, both water cooling and heating processes
will work simultaneously.
- If the appliance is not used for a long time, after the hot water has cooled, unplug the appliance and
unscrew the drain plug behind the appliance to drain the remaining water into the hot water tank, then
screw the plug to place. Open the cold water tap to drain the cold water tank.
- If no water is flowing to the cold water faucet, turn off the cooling switch until the water is flowing
to the faucet.
- If you do not use hot water for more than 3 days, we recommend that you switch off the hot water
heater switch.
IMPORTANT !!!
Turn on the appliance only after water starts to
flow through the two taps.
WARNING:
Avoid contact with hot water.
5
English