PROFESSIONAL TWO-WAY RADIO
09
PROFESSIONAL TWO-WAY RADIO
10
GETTING STARTED
I
nstall & Remove the Battery
Installing Battery Pack
Align the battery pack with the grooves on the
back chassis of the radio.
Slide the battery pack along the chassis until it
fits into the top groove with a “Click”.
Removing Battery Pack
Push the battery pack latch rightward to unlock
and release the battery.
When the battery pack is released from the
groove, push the battery pack downward and
remove it.
Install & Remove the Antenna
Install the Antenna
1.Switch off the radio; insert the threaded end
of the antenna into the antenna connector on
the top of the radio.
2.Screw down the antenna clockwise until it is
secure.
Remove the Antenna
Switch off the radio then turn the antenna
counter-clockwise to remove.
Install & Remove the Belt Clip
Install the Belt Clip
Remove the battery off the radio. Line up the
holes of the belt clip with those on the radio
and insert both screws. Tighten clockwise
using a screwdriver until secure.
Remove the Belt Clip
Unscrew both screws from the holes and
remove belt clip.
No. Unit Remarks
Press SK1 or SK2 key to enable
the specific function which has
been programmed via software.
Press this key to activate the
function (1 Beep) and press again
to deactivate (2 Beeps). SK1 is
factory set on Monitor & Call Ring
9 Side Key 2 (SK2)
8 Side Key 1 (SK1)
10 Battery’s DC Jack
Charge battery directly using
supplied mains charger
11 SP/MIC Jack Dustproof and Rainproof
12 Battery Pack
SK2 is factory set on VOX (voice
activation / hands-free)
Summary of Contents for ZA-758
Page 1: ......
