zarges 41286, Instructions For Assembly And Use, Page: 4 / 50

4
1. Information on this manual
The instructions in this manual must be read, understood and complied with to ensure
correct and safe erection and operation of the fixed ladders. Failure to comply with these
instructions may lead to fatal accidents, injury or damage to property.
This manual must be available at the assembly/installation location at all times and
must be read, understood and the instructions in it followed by all persons assembling/
installing the fixed ladder.
1.1 Regulations
In addition to the instructions in this manual, the following regulations must be
complied with when installing, using and servicing the equipment:
• DGUV Rule 100-001 - Principles of prevention
• DGUV Regulation 38 - Construction work (formerly BGV C22)
• DGUV Regulation 21 - Waste water plants (formerly BGV C5)
• DGUV Principle 312-906 - Principles for selection, training and certification of
experts for personal protective equipment providing protection against falling
(formerly BGG 906)
• DGUV Information 201-002 - Structural engineering (formerly BGI 530)
• DGUV Rule 11-198 Rules for the use of personal protective equipment against falls
from a height (formerly BGR/GUV-R 198)
• DIN 18799:1:2009-05 Fixed ladders for construction work
• DIN 14094-1:2017-04 Firefighting purposes - Escape ladder installations - Escape
ladder with falling protection, holding device, platform
• DIN EN ISO 14122-4:2016-10 Safety of machinery - Permanent means of access to
machinery - Part 4: Fixed ladders (ISO 14122-4:2016)
1.2 Copyright and
trademark rights
Copyright of these instructions for assembly and use rests with the manufacturer.
The manufacturer also reserves all rights arising from this documentation, in particular
in connection with the granting of a patent or registration of utility patents.
Any infringement of the conditions described above will result in liability for damages.
1.3 Structure of the
manual
The description of procedure for assembly of the fixed ladder system is contained in the
illustrations section of this manual. The following must also be observed during assembly:
> Safety instructions in Chapter 4.3 Special notes
The illustrations section of the manual is structured as follows:
Contents Page Identification
Information on products 21
Information on assembly 23
Assembly 24
to
Supporting forces for platform
combinations
42
A1 A30
B