25
Error messages:
If there are errors, regarding program interpretation of access to an SD card, see item 3.3.1 [Error
Messages].
Attempting to exceed physical or base coordinates.
Stopping the process:
See item 2.1.8. [General error messages regarding travels],
Critical ruler errors:
See item 2.1.8. [General error messages regarding travels],
Error when returning to the beginning of program:
A burn occurred and the working bit of the
machine has returned to the beginning of the program currently in progress.
Error when returning to the beginning of segment:
A burn occurred and the working bit of the
machine has returned to the beginning of the current segment of the program.
Excessive temperature in radiator, temperature or level of kerosene.
Burn:
A burn has been detected.
The starting level of coordinate Z has been exceeded by 5mm. :
When drilling, the working bit of the
machine has exceeded the starting point of the program by 5mm.
Travel Home.
5
A pattern of preparatory procedures, before commencing a EDM
process
1)
Go to the
“
Manual Working Mode
”
and position the electrode in relation to a workpiece.
2)
Travel the machine to the workpiece.
3)
Travel away from the workpiece, according to a pre-defined value.
4)
Reset the operator's coordinates: see item 2.2.1. [Operator
’
s coordinates]
5)
Set the appropriate physical coordinates (adjusted to the G-code applied in the working program): see
item 2.2.2. [A list of base coordinates]
6)
Go to
“
Programming
”
and load the program you intend to use: see item 3.1. [List of programmes]
7)
Go to the
“
Automatic Working Mode
”
and start drilling: see item 4 [The
“
Automatic Working Mode
”
].
