Shelf Support Rails
Removing the shelf support rails
1
Pull the front of the
shelf support rail away
from the side wall.
1
2
2
Pull the rear shelf sup-
port rail away from the side
wall and remove it.
Installing the shelf support rails
Install the shelf support rails in opposite sequence.
The rounded ends of the shelf support rails must
point to the front!
What to do if…
Warning! Refer to "Safety information" chapter.
Problem
Possible cause
Remedy
The oven does not heat up
The oven is switched off
Switch on the oven
The clock is not set
Set the clock
The necessary settings are not set
Check the settings
The automatic switch off is on
Refer to “Automatic switch off”
The switch-on lock is on
Refer to "Switching off the switch-on
lock"
The fuse in the fuse box is released
Check the fuse
If the fuse is released more than one time,
contact a qualified electrician
Demo mode is on
Refer to "Demo mode"
The display shows an error
code “F.."
There is an electronic fault.
Write down the error code and contact
the Service Center.
The oven lamp does not op-
erate
The oven lamp is defective
Replace the oven lamp
Steam and condensation set-
tle on the food and in the oven
cavity
You left the dish in the oven for too long Do not leave the dishes in the oven for
longer than 15-20 minutes after the
cooking process ends
If you cannot find a solution to the problem yourself,
contact your dealer or the service centre.
The necessary data for the service centre is on the rating
plate. The rating plate is on the front frame of the oven
cavity.
34