19
After this procedure, it will be necessary to set
the programme and the options again and then
to press button
.
At the end of the programme
The washer dryer stops automatically. Some
acustic signals sound and on the display will
appear three flashing «
0.00
». The button
light goes off. The door can be opened.
If, at the end of a programme, there is water in
the tub, to empty out the water follow the
following instructions:
To empty out the water proceed as follows:
1. turn the programme selector dial to «O»
2. select the Drain»or «Spin» programme
8
8
3. reduce the spin speed, if needed, by
pressing button
4. press button
5. at the end of the programme, the display
shows the display shows «
0.00
», it will be
possible to open the door.
Turn the programme selector dial to «O» to
switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty.
If you do not intend to carry out another wash,
close the water tap.
Leave the door open to prevent the formation
of mildew and unpleasant smells.
8
3
Drying only
The max load to dry in your washer -dryer is 3
kg for cotton and 2 kg for synthetics.
The water tap must be open and the drain
hose must be positioned in the sink or
connected to the drain pipe.
1. Load the laundry.
2. Turn the selector dial to «Cottons» or
«Synthetics» programme in the «Drying»
sector.
3. If you wish to select the automatic drying
(Exta dry, Store dry or Iron dry), press
button
until the light corresponding to
the desired dryness degree for synthetics
or cotton illuminates.
4. If you wish to select a timed drying, press
button
until the time you want appears
on the display (see the drying pro-
grammes).
Note!
The drying time will automatically increase by
up to 2 minutes. this is quite normal.
5
4
5. Press button
to start the programme.
After the programme has started, the time
remaining is updated every minute.
6. At the end of the programme, the buzzer
sounds. Three flashing zeros «
0.00
»
appear on the display.
The last 10 minutes of the drying cycle cor-
respond to an anti-crease phase. During
this time the door is locked and the display
keeps showing three flashing zeros
«
0.00
».
Note!
If you whish to open the door before or
during the anti-crease phase or to interrupt
it, press any button or turn the programme
selector dial to any programme position
(except «O»), the door can be immediately
opened.
7. Turn the selector dial to the «O» position to
switch the machine off. Remove the laun-
dry.
8
132966020.qxd 30/01/2008 15.37 Pagina 19
