18
selected delay can be modified only after you
have turned the programme selector dial to
the «O» position and after you have selected
the programme again.
• The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washer dryer to PAUSE by
pressing button
. After you have closed
the door, press the same button again.
Note!
The Delay Start cannot be selected with
«Drain» programme.
Select an additional rinse
This appliance is designed for saving water.
However, for people with a very delicate skin
(allergic to detergents) it may be necessary to
rinse the laundry using an extra quantity of
water (extra rinse)
Press simultaneously buttons
and for
a few seconds until the pilot light
will light up.
This function stays permanently on.
To remove this function press the same buttons
again until the pilot light
goes off.
Start the programme by pressing button
To start the selected programme, press this
button; the corresponding green pilot light
stops flashing. The appliance starts operating
and the door is locked.
To interrupt a programme which is running,
press button
: the green pilot light starts to
flash.
To restart the programme from the point at
which it was interrupted, press button
again.
If you have chosen a delayed start, the
machine will begin the countdown.
8
8
8
9
9
6
4
8
IMPORTANT!
If an option which is not compatible with the set
wash programme is selected, the message Err
is displayed for a few seconds and the red light
of this button flashes for 3 times.
Altering an option or a running programme
It is possible to change the options before the
programme carries it out.
Before you make any change, you must pause
the machine by pressing button
.
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to «O» and then to the new
programme position. Start the new programme
by pressing button
again.
The washing water in the tub will not empty
out.
Interrupting a programme
Press button
to interrupt a programme
which is running, the corresponding light starts
to flash. Press the button again to restart the
programme.
Cancelling a programme
Turn the selector dial to «O» to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing
button
. The door can be opened.
If the door is still locked, this means that the
machine is already heating, that the water level
is above the bottom edge of the door.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «O». The door can
be opened after a few minutes.
(Pay attention to the water level and
temperature!).
8
8
8
8
132966020.qxd 30/01/2008 15.37 Pagina 18
