ENGLISH 27
In case of power failure or appliance failure,
the appliance door remains locked.
The wash program continues when power is
restored. If the door remains locked in case
of failure, it is possible to open it using the
emergency unlock feature.
Before Opening The Door:
9.2
Emergency Door Opening
Make sure that the water temperature
and the laundry are not hot. Wait until
they cool down if necessary.
WARNING!
Make sure that the drum is not rotating.
Wait until the drum stops rotating if
necessary.
●
●
Malfunction
Possible Cause
Solution
The electronic unbalance detection device has
cut in because the laundry is not evenly
distributed in the drum. The laundry is
redistributed by reverse rotation of the drum.
This may happen several times before the
unbalance disappears and normal spinning
can resume. If, after 10 minutes, the laundry is
still not evenly distributed in the drum, the
machine will not spin. In this case, redistribute
the load manually and select the spin program.
Pause the machine and
redistribute laundry
manually.
Machine not installed properly.
Make sure the levelling of
the appliance is correct.
Refer to “Installation”.
Make sure that the
packaging and/or the
transit bolts are removed.
Refer to “Unpacking”.
Transit bolts or packaging not removed.
The load may be too small.
Add more laundry in the
drum.
Spinning starts
late or the
machine does
not spin:
The machine
makes an
unusual noise:
If you are unable to identify or solve the
problem, contact our service centre.
Before calling service centre, make a note
of the model, serial number and purchase
date of your machine: the Service Centre
will require this information.
Make sure that the water level inside
the drum is not too high. If necessary,
perform an Emergency Drain
(see page 24).
●
2.
Remove the filter door, as picture below.
squeeze
To open the door proceed as follows:
1.
Turn the program selector dial to “Off” to
switch the appliance off. Disconnect the
main plug from the main socket.
