24 www.zanussi.com
Remove the water inlet hose from
the water tap.
Clean the filter in the inlet hose with
a stiff brush.
If your water is very hard or contains
traces of lime deposit, the water inlet
filter may become clogged. It is therefore
a good idea to clean it from time to time.
8.8
Cleaning The Water Inlet
Filter
To clean the water inlet filters:
1.
Close the water tap.
2.
3.
4.
5.
6.
7.
Open the water tap.
Remove the inlet hose behind the
appliance.
Clean the filter in the valve with a
stiff brush or a towel.
Install the inlet hose again. Make
sure that the couplings are tight to
prevent leakages.
If the appliance is installed in an area where
the temperature can be less than 0 °C,
remove the remaining water from the inlet
hose and the drain pump.
Emergency Drain
8.9
Frost Precautions
Disconnect the main plug from the main
socket. Turn off the water tap.
1.
2.
Remove the water inlet hose.
3.
Remove the drain hose from the rear
support and unhook it from sink or spigot.
Put the end of the drain and inlet hose in a
container. Let the water flow out of the
hoses.
4.
5.
When no more water flows, install the inlet
hose and the drain hose again.
NOTE:
Make sure that the temperature
is more than 0 °C before you use the
appliance again.
45°
35°
