Zanussi ZWD86SB4PW, User Manual

Page: 32 / 40

Problem Possible solution
The spin phase does
not operate or the
washing cycle lasts lon-
ger than usual.
• Set the spin programme.
• Make sure that the drain filter is not clogged. Clean the filter, if neces-
sary. Refer to "Care and cleaning".
• Adjust manually the items in the tub and start the spin phase again.
This problem may be caused by balance problems.
There is water on the
floor.
• Make sure that the couplings of the water hoses are tight and there is
not water leakages.
• Make sure that the water inlet hose and the drain hose have no dam-
ages.
• Make sure you use the correct detergent and the correct quantity of it.
You cannot open the
appliance door.
• Make sure that a washing programme that ends with water in tub, has
not been selected.
• Make sure that the washing programme is finished.
• Set the drain or the spin programme if there is water in the drum.
• Make sure that the appliance receives electrical power.
• This problem may be caused by a failure of the appliance. Contact the
Authorised Service Centre.
If you need to open the door, please read carefully "Emergency door
opening".
The appliance makes an
unusual noise and vi-
brates.
• Make sure the levelling of the appliance is correct. Refer to "Installa-
tion instruction".
• Make sure that the packaging and/or the transit bolts are removed.
Refer to "Installation instruction".
• Add more laundry in the drum. The load may be too small.
The programme dura-
tion increases or de-
creases during pro-
gramme execution.
• The TimeCare System is able to adjust the programme duration ac-
cording to the type and the laundry load size. Refer to "The TimeCare
System load detection" in "Daily Use" chapter.
The washing results are
not satisfactory.
• Increase the detergent quantity or use a different detergent.
• Use special products to remove the stubborn stains before you wash
the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
Too much foam in the
drum during the wash-
ing cycle.
• Reduce the quantity of detergent or the number of tablets or single-
dose detergents.
After the washing cycle,
there are some deter-
gent residues in the dis-
penser drawer.
• Make sure that the flap is in the correct position (UP for powder deter-
gent - DOWN for liquid detergent).
• Make sure you have used the detergent dispenser according the indi-
cations given in this user manual.
The appliance does not
dry or does not dry cor-
rectly.
• Turn the water tap on.
• Make sure the drain filter is not clogged.
• Reduce the laundry load.
• Make sure you have set the correct cycle. if necessary, set again a
short drying time.
32