Zanussi ZWD86SB4PW, User Manual

Page: 21 / 40

Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
OPENING THE DOOR
CAUTION! If the temperature and
level of the water in the drum are too
high and the drum still rotates, you
cannot open the door.
While a programme or the delay start operates, the
appliance door is locked and the display shows the
indicator
.
Open the appliance door when the
programme or the delay start operates:
1. Press to pause the appliance.
2. Wait until the door lock indicator goes off.
3. Open the door.
4. Close the door and press again
.
The programme or delay start continues to operate.
AT THE END OF THE PROGRAMME
• The appliance stops automatically.
• The acoustic signal operates (if it is activated).
• In the display comes on.
• The indicator of the
goes off.
• The door lock indicator goes off.
• You can open the door.
• Remove the laundry from the appliance. Make
sure that the drum is empty.
• Close the water tap.
• Turn the programme knob to position to
deactivate the appliance.
• Keep the door ajar, to prevent the mildew and
odours.
The washing programme is completed, but
there is water in the drum:
• The drum turns regularly to prevent the creases
in the laundry.
• The door lock indicator is on. The indicator
flashes. The door stays locked.
• You must drain the water to open the door.
To drain the water:
1. If necessary, decrease the spin speed. If you
set , the appliance only drains.
2. Press . The appliance drains the water and
spins.
3. When the programme is completed, and the
door lock indicator goes off, you can open
the door.
4. Turn the programme knob to position to
deactivate the appliance.
The appliance drains and spins
automatically after approximately 18
hours (except for Wool programme).
STAND-BY
Some minutes after the end of the washing
programme, if you do not deactivate the appliance,
the energy saving status activates.
The energy saving status decreases the energy
consumption when the appliance is on the stand
by.
• All indicators and the display go off.
• The indicator of the
flashes slowly
• Press one of the options to deactivate the
energy saving status.
If you set a programme or an option
that ends with water in the drum, the
energy saving status function doesn't
activate to remind you to drain the
water.
DAILY USE - DRYING ONLY
WARNING! Refer to Safety chapters.
This appliance is an automatic washer
dryer.
DRYING SETTING
WARNING! Make sure that the
water tap is open.
1. Turn the programme knob to the desired
programme to activate the appliance.
2. Load the laundry one item at a time.
21