8
If you have selected a delay start by means of the
“
Delay Start
” button, the countdown will begin and
will be shown on the display.
•
Pause
: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the
programme, press the button again.
Important!
You must set the washing machine to
PAUSE before you make any change in the programme
in progress.
10 Display
The following pieces of information are shown on the
display:
•
Duration of washing programme
in hours
and minutes, after you have selected a programme
(for example
2.05
) .
The duration is calculated automatically on the basis of
the maximum recommended load for each type of
fabric.
After the programme has started, the time remaining is
updated every minute.
•
The washing machine has completed the
programme
: this is indicated by a
flashing
zero.
•
The washing machine has stopped with water in
the tub,
at the end of a programme with the “
Rinse
Hold
” option
: this is indicated by a
flashing
zero.
•
Selected drying time
in minutes or hours and
minutes.
1.25
2.05
After starting the programme, the remaining time is
updated every minute.
•
Delay start
, a time value indicated in hours and
selected by means of the relevant button (max 23
hours).
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the “
Start Pause
” button, the
countdown begins, and the delay time value decreases
by one unit every hour and then, when 2 hours remain,
the time decreases in 30 minute intervals.
You can delay the start of the selected programme by
up to 23 hours in one hour intervals.
•
An incorrect option selection has been made
: this is
indicated by the message
Err
when a function
incompatible with the current programme is selected.
•
An alarm code
indicates a fault in the machine
operation (see the relevant chapter on page 21-22).
E20
