11
7. Select the “Delay Start”
Before you start the programme
, if you wish the
starting to be delayed, press the “
Delay Start
” button
repeatedly, or keep it pressed, to select the desired delay.
The selected delay time value (up to 23 hours) will
appear on the display for 3 seconds, then the duration of
the programme will appear again.
8. Start the programme
Press the “
Start Pause
” button. The relevant light will
stop flashing and only the light relevant to the phase that
is in progress will remain lit.
If you have chosen a delayed start, the washing machine
will begin the countdown.
The display will show the duration of the programme or
the selected delay.
How to change an option or a
programme during its cycle
Before you make any change, you must pause the
machine by pressing the “
Start Pause
” button.
It is possible to change any option before the
programme carries it out.
Changing a running programme is possible only by
cancelling it and selecting a new programme. Turn the
programme selector dial to “
Off
” and then to the
selected programme. Start it by depressing the “
Start
Pause
” button.
The machine will resume the cycle
from the beginning
and the washing water in the tub will not emptied out.
Start
Pause
Delay
Start
How to interrupt a programme
Depress the “
Start Pause
” button to interrupt a
programme which is running, the corresponding light
starts to flash.
How to cancel a programme
during its cycle
Turn the selector dial to “
Off”
to cancel a programme
which is running. Now you can select a new
programme.
How to open the door during the
cycle of a programme
First set the machine to PAUSE by pressing the “
Start
Pause
” button.
If the door does not open, this means that the machine is
already heating, that the water level is above the bottom
edge of the door or that the drum is turning.
If you cannot open the door but you need to open it you
have to switch the machine off by turning the
programme selector dial to “
Off”
.
After about 3 minutes the door can be opened.
Pay attention to the level and temperature of the
water in the machine !
After closing the door, turn the programme selector dial
to the programme previously selected and start it by
depressing the “
Start Pause
” button.
9. End of the programme
The machine stops automatically, the “
Start/Pause
”
button light goes out and the display shows a flashing
zero. The “
End
” light illuminates.
If the Rinse Hold
option has been selected, the
“
Start/Pause
” button light goes out, the
light and
the “
Rinse Hold
” pilot lights remain lit to indicate that
the water must be emptied out before opening the door.
The display shows a blinking zero and the “
End
” light
is alight.
When the programme has been completed, a flashing
zero appears on the display.
Release of the lock is also indicated by the illumination
of the “
End
” light.
Turn the programme selector dial to Reset “
Off”
to
switch the machine off.
