20
Remove the little plates and make the holes with a
diam. of 2 mm. Replace the little plates over the
runners and screw in the screws provided
(3.5x16 mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted holes.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
In case of side fixing of the appliance, it will be
sufficient to loosen the screws fixing the brackets (G)
and to position them as shown in Fig. 11. Finally,
mount the cover (H).
The doors can be opened using the sliding system
previously illustrated, or one of the two doors can be
opened by fitting the small handle supplied as an
accessory.
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by
±
6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
Fig. 10
Fig. 11
Fig. 12
PR35
D708
G
H
G
D029
TECHNICAL SPECIFICATION
The technical data is indicated in the rating plate on the left side inside the appliance.
GB
