Opening the door after the programme
has started
First set the machine to pause by pressing the
button
7
.
If the pilot light
9
blinks and after a few minutes
goes off, the door can be opened.
If the pilot light
9
remains lit, this means that the
machine is already heating or that the water lev-
el is too high. In any case, do not try to force
the door open!
If you cannot open the door but you need to
open it, you have to switch the machine off by
turning the selector dial to
. After a few mi-
nutes the door can be opened.
(Pay attention to the water level and tem-
perature!).
After closing the door, it is necessary to select
the programme and options again and to press
button
7
.
At the end of the programme
The machine stops automatically. The blinking
appears on the display, the pilot light of but-
ton
7
and the pilot light
9
go off.
If a programme or an option that ends with wa-
ter left in the tub has been selected, the pilot
light
9
remains on and the door is locked to in-
dicate that the water must be emptied out be-
fore opening the door.
Before you empty out the water, the drum con-
tinues to run at regular intervals until the water
draining.
Follow the below instructions to empty out the
water:
1.
Turn the programme selector dial to
.
2.
Select the draining or spinning programme.
3.
Reduce the spin speed if needed, by
pressing the relevant button.
4.
Press button
7
.
At the end of the programme, the door is re-
leased and can be opened. Turn the pro-
gramme selector dial to
to switch the ma-
chine off.
Remove the laundry from the drum and carefully
check that the drum is empty. If you do not in-
tend to carry out another wash, close the water
tap. Leave the door open to prevent the forma-
tion of mildew and unpleasant smells.
Stand by
: once the programme has finished
after a few minutes the energy saving system
will be enabled. The brightness of the display is
reduced. By pressing any button the appliance
will come out of the energy saving status.
Use - Drying
Drying only
Caution!
The recommended load size is 4 kg for cottons
and linen and 3 kg for synthetic items.
By pressing
Drying Time
button it is also
possible to dry up to 6 kg of cotton items
(see the «Drying Programme » table).
Caution!
The water tap must be open and the drain
hose must be positioned in the sink or
connected to the drain pipe.
1.
Load the laundry.
2.
Select a spin cycle at the maximum spin
speed allowed for the type of laundry in or-
der to obtain the best drying performances.
3.
Select the drying programme for Cottons
or Synthetic in the Drying sector of the
programme selector dial.
4.
If you wish to select an
automatic drying
(for cottons and synthetic items only),
press the button
3
until the pilot light cor-
responding to the required dryness degree
illuminates.
5.
If you wish to select a
timed drying
, press
the button
4
until the time you want ap-
pears on the display (see the «Drying Pro-
gramme» table). Every time you press this
17
www.zanussi.com
