To enable or disable this option press simulta-
neously for about 6 seconds buttons
2
and
3
until on the display, the icon
appears or dis-
appears.
Daily Use
Load the laundry
Open the door by
carefully pulling the
door handle out-
wards. Place the
laundry in the drum,
one item at a time,
shaking them out as
much as possible.
Close the door.
Make sure that no
laundry stays be-
tween the seal and
the door. There is a
risk of water leakage
or damage to the
laundry.
Measure out the detergent and the fabric
softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent re-
quired, pour it into the main wash compart-
ment
or in the appropriate compartment if
the selected programme/option it requires
(see more details in "Detergent dispenser
drawer").
If required, pour fabric softener into the com-
partment marked
(the amount used must
not exceed the «MAX» mark in the drawer).
Close the drawer gently.
Select the required programme by means
of the programme selector dial (1)
Turn the programme selector dial to the re-
quired programme.
The green pilot light of button
7
starts to flash.
The selector dial can be turned either clockwise
or anticlockwise.
Turn the selector dial to position
to reset the
programme/to switch the machine OFF.
At the end of the programme the selector
dial must be turned to position
, to
switch the machine off.
Important!
If you turn the programme selector
dial to another programme when the machine is
working, the red pilot light of button
7
will blink
3 times and the message
Err
is displayed to
indicate a wrong selection. The machine will
not perform the new selected programme.
Select the spin speed by pressing button
2
When selecting a programme, the appliance
proposes automatically the maximum spin
speed provided for that programme. (See
"Washing programmes" for the maximum al-
lowed spin speed).
Press this button repeatedly to change the spin
speed, if you want your laundry to be spun at a
different speed. The relevant pilot light illumi-
nates.
Select the available options by pressing
the buttons 5 and 6
Depending on the programme, different options
can be combined. These must be selected after
choosing the desired programme and before
starting the programme. When these buttons
are pressed, the corresponding pilot lights illu-
minate. When they are pressed again, the pilot
lights go out. If an incorrect option is selected,
the integrated
red
pilot light of the button
7
flashes 3 times and the message
Err
is dis-
played.
15
www.zanussi.com
