Zanussi ZJB9476, User Manual, Page: 13 / 52

1
2
3
90
o
• Refit the bracket on the adjustment
screws and screw the nuts with
washers without tightening them
down.
• Close the door and check that the
small door is positioned at the re-
quired height, operating the ad-
justment screws if necessary.
• Use the same screws for vertical
alignment of the small doors.
• If necessary, carry our horizontal
alignment by shifting the small
doors.
• After aligning the doors, tighten
the nuts of the brackets and the
screws of the small bracket.
• Fix the bracket located under the
door to the panel with the two plas-
tic washers contained in the box of
accessories.
• Then refit the bracket cover.
Building the appliance in
1
2
• Fit the appliance into the recess.
• Rotate the bracket of 180° in order to obtain the right
position ( 2). The position (1) is on the delivery.
• Fix it to the wall with the appropriate bracket.
50
50
25
• The top of the appliance must be kept clear to allow
better air circulation.
If a wall unit is fitted above the appliance, there must
be a gap of 50 mm between this unit and the wall and
it must be at least 50 mm below the ceiling.
Fitting the plinth
Alignment height of 820 mm
13