Zanussi ZFC31401WA, User Manual

Page: 21 / 52

Problem Possible cause Solution
The appliance is noisy. The appliance is not supported
properly.
Check if the appliance stands
stable.
Audible or visual alarm is on. The cabinet has been recently
switched on or the temperature
in the appliance is too high.
Refer to "High Temperature
Alarm" and if the problem still oc-
curs contact the nearest Author-
ized Service Centre.
Power indicator light is flashing. An error has occurred in measur-
ing the temperature or the appli-
ance is not working properly.
Contact the nearest Authorized
Service Centre.
The lid doesn't close completely. Food packages are blocking the
lid.
Arrange the packages in the right
way, see the sticker in the appli-
ance.
There is excessive frost. Eliminate excess frost.
The lid is difficult to open. The lid gaskets are dirty or sticky. Clean the lid gaskets.
The valve is blocked. Check the valve.
The lamp does not work. The lamp is defective. Refer to "Replacing the lamp".
The compressor operates contin-
ually.
Temperature is set incorrectly. Refer to "Operation" chapter.
Large quantities of food to be
frozen were put in at the same
time.
Wait some hours and then check
the temperature again.
The room temperature is too
high.
Refer to climate class chart on
the rating plate.
Food placed in the appliance
was too warm.
Allow food to cool to room tem-
perature before storing.
The lid is not closed properly. Check if the lid closes well and
the gaskets are undamaged and
clean.
There is too much frost and ice. The lid is not closed correctly or
the gasket is deformed/dirty.
Refer to "Closing the door".
The water drainage plug is not
correctly positioned.
Position the water drainage plug
in the correct way.
Temperature is set incorrectly. Refer to "Operation" chapter.
The temperature in the appliance
is too low/too high.
The temperature regulator is not
set correctly.
Set a higher/lower temperature.
The door is not closed correctly. Refer to "Closing the door".
www.zanussi.com 21