Zanussi ZDS 6070, Instruction Booklet

Page: 21 / 26

43
This dishwasher is designed to be fitted under a
kitchen counter or worksurface.
It is essential that the recess dimensions indicated in
the diagram are followed.
No further openings for venting of the dishwasher are
required, but only to let the water fill and drain hose
and power supply cable pass through.
The recess height may be anywhere between 820 and
900 mm from the floor as the dishwasher incorporates
adjustable feet (max 80 mm).
A distance of 2 mm should be allowed between the
top of the dishwasher and the counter top.
Adjusting the height of the
appliance
To adjust the height proceed as follows:
1. Loosen or tighten the two front feet.
2. The rear foot is adjusted by turning the screw in the
middle of the front kick plate to the left or right.
A pad is supplied for the rear foot to make sliding the
appliance in and out of the recess easier.
To fit the pad, press it onto the rear foot.
If required, the dimensions of this pads can be
reduced by breaking it where marked.
Good levelling is essential for correct closure and
sealing of the door. When the appliance is correctly
levelled, the door will not catch on the levelling
spacers on either side of the cabinet.
If the door does not close correctly, loosen or tighten
the adjustable feet until the machine is perfectly level.
INS09en
600
596
600
+
-
596
820
900
÷
8
18
8
98
÷
II94
590
max
II52
Building-in