Zanussi ZDS 6070, Instruction Booklet

Page: 19 / 26

41
Remove all packaging before positioning the
machine.
If possible, position the machine next to a water tap
and a drain.
Any electrical work required to install
this appliance should be carried out by a
qualified electrician or competent
person.
Any plumbing work required to install
this appliance should be carried out by a
qualified plumber or competent person.
Water supply connections
This dishwasher may be fed with either hot (max. 60°)
or cold water.
Nevertheless we advise you a cold water supply.
A hot water supply is not always efficient with very
soiled crockery as it shortens the washing
programmes a lot.
The water pressure must be within the limits given in
the technical specifications.
Your local Water Authority will advise you on the
average mains pressure in your area.
The dishwasher features fill and drain hoses which
can be turned either to the left or the right to suit the
installation.
The locknut must be correctly fitted to avoid water
leaks.
Avoid bends or kinks in the hose which could prevent
or slow down the water supply.
If the machine is connected to new pipes or pipes
which have not been used for a long time, you should
run the water for a few minutes before connecting the
inlet hose. This will prevent deposits of sand or rust
clogging the inlet hose filter.
For making the connection itself, the coupling nut fitted
to the machine’s supply hose is designed to screw
onto either a 3/4 inch gas thread spout, or to a
purpose made quick-coupling tap such as the Press-
block.
The inlet hose is fitted with a safety
device to prevent inadvertent loosening.
To detach the hose, press the lever (B) and turn the
retaining ring (A) anticlockwise.
COL01en
A
CA14
B
Installation instructions