Zanussi ZDS 2010, User Manual

Page: 13 / 20

Fault code and malfunction Possible cause and solution
The programme does not start • The appliance door is not closed.
Close the door.
• Mains plug is not connected in.
Put in the mains.
• The fuse has blown out in the household fuse box.
Replace the fuse.
• Delay start is set.
Cancel the delay start to start the programme immediately.
After the check, switch on the appliance. The programme
continues from the point of interruption. If the malfunction
shows again, contact your Service Force Centre.
For other fault codes, not described in the chart, contact
your Service Force Centre.
These data are necessary to help you quickly and cor-
rectly:
• Model (Mod.)
• Product number (PNC)
• Serial number (S.N.)
For these data, refer to the rating plate.
Write the necessary data here:
Model description : ..........
Product number : ..........
Serial number : ..........
The cleaning results are not satisfactory
The dishes are not clean • The selected washing programme is not applicable for the type of load and
soil.
• The baskets are loaded incorrectly so that water cannot reach all surfaces.
• Spray arms do not turn freely because of incorrect arrangement of the load.
• The filters are dirty or not correctly installed.
• The quantity of detergent is too little or missing.
Limescales particles on the dishes • The salt container is empty.
• The water softener is adjusted on a wrong level.
• The salt container cap is not closed correctly.
The dishes are wet and dull • No rinse aid has been used.
• The rinse aid dispenser is empty.
There are streaks, milky spots or
a bluish coating on glasses and
dishes
• Decrease the rinse aid dosage.
Dry water drop signs on glasses
and dishes
• Increase rinse aid dosage.
• The detergent can be the cause.
Technical data
Dimensions Width cm 44,6
Height cm 85
13