Zanussi ZDS 2010, User Manual

Page: 12 / 20

External cleaning
Clean the external surfaces of the appliance and control
panel with a damp soft cloth. Only use neutral detergents.
Do not use abrasive products, scouring pads or solvents
(acetone, trichloroethylene etc...).
Frost precautions
Caution! Do not install the appliance where the
temperature is below 0 °C. The manufacturer is not
responsible for damage because of frost.
If not possible, empty the appliance and close the door.
Disconnect the water inlet hose and remove water from
the water inlet hose.
What to do if…
The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the problem
yourself. If you cannot find a solution to the problem
yourself, contact the Service Force Centre.
Caution! Switch off the appliance before you do the
below suggested corrective actions.
Fault code and malfunction Possible cause and solution
• continuous flash of the start/cancel in-
dicator light
• 1 flash of the end-of-programme indi-
cator light
The dishwasher does not fill with water
• The water tap is blocked or furred with limescale.
Clean the water tap.
• The water tap is closed.
Open the water tap.
• The filter in the water inlet hose is blocked.
Clean the filter.
• The connection of the water inlet hose is not correct. The hose can
be kinked or squashed.
Make sure that the connection is correct.
• continuous flash of the start/cancel in-
dicator light
• 2 flashes of the end-of-programme in-
dicator light
The dishwasher does not drain
• There is a blockage in the sink spigot.
Clean the sink spigot.
• The connection of the water drain hose is not correct. The hose can
be kinked or squashed.
Make sure that the connection is correct.
• continuous flash of the start/cancel in-
dicator light
• 3 flashes of the end-of-programme in-
dicator light
The anti-flood device operates
• Close the water tap and contact your local Service Force Centre.
12