Care and cleaning
To remove and clean the filters
Dirty filters decrease the washing results.
1
2
Clean the filters below
running water.
3
To remove filters B and C,
turn the handle approxi-
mately 1/4 counterclock-
wise .
4
Remove the flat filter A
from the bottom of the ap-
pliance.
5
Put the flat filter A in the
bottom of the appliance.
Install the flat filter cor-
rectly under the two
guides D.
6
Put the filter system in po-
sition. To lock the filter
system, turn the handle
clockwise until it locks in
position.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clogged, remove re-
maining parts of soil with a thin pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance and control
panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive cleaning pads or
solvents (acetone).
What to do if…
The start of the appliance does not occur or it stops dur-
ing operation.
First try to find a solution to the problem (refer to the ta-
ble). If not, contact the service centre.
With some malfunctions the indicators flash to show an
alarm code.
Alarm code
Malfunction
• The start/cancel indicator flashes continuously.
• The end indicator flashes one time intermittently.
The appliance does not fill with water.
• The start/cancel indicator flashes continuously.
• The end indicator flashes two times intermittently.
The appliance does not drain the water.
• The start/cancel indicator flashes continuously.
• The end indicator flashes three times intermittently.
The anti-flood device is on.
11
