Problem and alarm code
Possible cause and solution
Technical malfunction of the
appliance.
The display shows iC0 or iC3.
• Switch the appliance off and on.
The level of water inside the
appliance is too high.
The display shows iF1.
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right height
above the floor. Refer to the installation instructions.
The appliance stops and starts
more times during operation.
• It is normal. It provides optimal cleaning results and energy sav-
ings.
The programme lasts too long.
• If the delay start option is set, cancel the delay setting or wait
for the end of the countdown.
• Activating options can increase the programme duration.
The displayed programme du-
ration is different than the du-
ration in the consumption val-
ues table.
• The pressure and the temperature of the water, the variations of
the mains supply, the options, the quantity of dishes and the
degree of soil can change the programme duration.
The remaining time in the dis-
play increases and skips nearly
to the end of the programme
duration.
• This is not a defect. The appliance is working correctly.
Small leak from the appliance
door.
• The appliance is not levelled. Loosen or tighten the adjustable
feet (if applicable).
• The appliance door is not centred on the tub. Adjust the rear
foot (if applicable).
The appliance door is difficult
to close.
• The appliance is not levelled. Loosen or tighten the adjustable
feet (if applicable).
• Parts of the tableware are protruding from the baskets.
The appliance door opens dur-
ing the wash cycle.
• The AirDry function is activated. You can deactivate the func-
tion. Refer to "Basic settings".
Rattling or knocking sounds
from the inside of the appli-
ance.
• The tableware is not properly arranged in the baskets. Refer to
basket loading leaflet.
• Make sure that the spray arms can rotate freely.
The appliance trips the circuit-
beaker.
• The amperage is insufficient to supply simultaneously all the ap-
pliances in use. Check the socket amperage and the capacity
of the meter or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Authorised
Service Centre.
Once you have checked the appliance, deactivate
and activate the appliance. If the problem occurs
again, contact an Authorised Service Centre.
For alarm codes not described in the table, contact
an Authorised Service Centre.
WARNING! We do not recommend
using the appliance until the problem
has been completely fixed. Unplug the
appliance and do not plug it in again
until you are certain that it operates
correctly.
21
