18
For your safety
• Do not try to disconnect the appliance from the gas
supply if the supply pipe does not have a bayonet
connection, as described in the installation
instructions. If this is the case contact the person
who installed the appliance.
Location of appliance
• This appliance must not be installed in a bedsitting
room of volume less than 20m³ or in a bathroom,
shower room or garage. It is essential that the
appliance is positioned as shown.
• Curtains must not be fitted immediately behind the
appliance or within 150mm of the sides of the
hotplate. If fitted next to or between two base units
a minimum space of 1mm must be left between
each unit and the sides of the appliance. The hob
must be set to a minimum of 7mm above the
adjacent units. (Note: The levelling feet fitted to the
appliance will achieve a nominal height of 907mm -
5+ 13mm. Base units not meeting the above
conditions must be a minimum of 100mm away
from the hob.
• For appliances installed in the Republic of Ireland
please refer to NSAI-Domestic Gas Installation
IS813 Current Edition Section7 Permitted Locations
of appliance Table4— Locations and Permanent
Ventilation requirements-flueless appliances. Note:
- L.P.G. cookers MUST NOT be installed below
ground level i.e. in a basement or aboard any boat,
yacht or other vessel.
Levelling the appliance
• Adjustment to suit floor conditions or height is
obtained by rotating clockwise or anti clockwise the
feet at the front and rear of the appliance. A spirit
level should be placed on one of the shelves to
confirm the appliance is correctly levelled.
Connecting to gas supply
• This appliance is designed to be installed with an
appliance flexible connection only.
• Supply piping should not be less than R3/8.
Connection is made to the Rc ½ (½" B.S.P) female
threaded entry pipe located just below the hob level
on the rear left hand side of the appliance.
Only liquid sealants to be used when inlet gas pipe is
fitted i.e.: do not use P.T.F.E. sealant tape.
• Carry out a gas tightness test after connecting to
the gas supply.
• The gas bayonet connector must be fitted in the
enlarged area indicated.
• Take into account that it must be possible to pull
the appliance forward sufficiently. Ensure the hose
does not become trapped when pushing the
appliance into position.
Flexible tubing used must comply with BS. 669
current edition.
LPG Flexible connections must be a type suitable
for L.P.G and capable of operation up to 50 mbar
and carry a red stripe, band or label.
Fixing the stability chain
To further prevent tilting and for safe usage of the
appliance a stability chain should be used. Unscrew
the screw shown in the figure. Then, align the first
loop of the chain with the hole and assemble with the
screw so that the chain stands in its place safely.
Check the assembly by gently pulling the chain from
its loose end. Fix the loose end to the rear wall as
appropriate for your kitchen. The chain is not supplied
within the package of the appliance, but can easily be
supplied from the market.
min 150
min 7
min 1
750
max 400
IMPORTANT!
IMPORTANT!
