Zanussi ZBC34350X, User Manual

Page: 30 / 68

Problem Possible cause Remedy
The turntable set
makes a scratching or
grinding noise.
There is an object or dirt below the
glass cooking tray.
Clean the area below the glass
cooking tray.
The appliance stops
operating without a
clear reason.
There is a malfunction. If this situation repeats itself, call
the Authorised Service Centre.
SERVICE DATA
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service
Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the appliance. Do
not remove the rating plate from the appliance.
We recommend that you write the data here:
Model (MOD.) ........................................
Product number (PNC) ........................................
Serial number (S.N.) ........................................
INSTALLATION
WARNING! Refer to Safety chapters.
GENERAL INFORMATION
CAUTION! Do not block the air vents.
If you do that, the appliance can
overheat.
CAUTION! Do not connect the
appliance to adapters or extension
leads. This can cause overloading and
risk of fire.
CAUTION! The minimum installation
height is 85 cm.
• Put the microwave far away from steam, hot air
and water splashes.
• If the microwave is too close to a radio or TV set
it may cause interference in the received signal.
• If you transport the microwave in the cold
weather, do not activate it immediately after the
installation. Let is stand in the room temperature
and absorb the heat.
ELECTRICAL INSTALLATION
WARNING! Only a qualified person
must do the electrical installation.
The manufacturer is not responsible if
you do not follow the safety
precautions from the chapter "Safety
Information".
This microwave is supplied with a main cable and
main plug.
The cable has an earth wire with an earthing plug.
The plug must be plugged into an outlet that is
properly installed and earthed. In the event of an
electrical short circuit, earthing reduces the risk of
electric shock.
INSTALLING THE MICROWAVE
1. Check if the dimensions of the furniture meet
the installation distances.
30