• The appliance must not be located close to
radiators or cookers.
• Make sure that the mains plug is accessible
after the installation of the appliance.
• Connect to potable water supply only (If a
water connection is foreseen).
Service
• Any electrical work required to do the servic-
ing of the appliance should be carried out by
a qualified electrician or competent person.
• This product must be serviced by an author-
ized Service Centre, and only genuine spare
parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in ei-
ther its refrigerant circuit or insulation materials.
The appliance shall not be discarded together
with the urban refuse and rubbish. The insula-
tion foam contains flammable gases: the appli-
ance shall be disposed according to the appli-
cable regulations to obtain from your local au-
thorities. Avoid damaging the cooling unit, es-
pecially at the rear near the heat exchanger.
The materials used on this appliance marked by
the symbol
are recyclable.
Control panel
Freezer Control panel
1
2
3
5
6 7 8
9
4
1.
Pilot light
2.
ON/OFF switch
3.
Temperature regulator (warmest)
4.
Temperature indicator
5.
Temperature regulator (coldest)
6.
Alarm light
7.
Alarm reset switch
8.
Action Freeze light
9.
Action Freeze switch
Switching on
Insert the plug into the wall socket.
Press the ON/OFF switch .
The Pilot Light will light up.
Switching off
The freezer is shut off by pressing the ON/OFF
switch until the Pilot light and the Temperature
indicator switched off.
Temperature regulation
The temperature can be adjusted between
-15°C and -24°C.
By pressing the Temperature regulators , the
current temperature setting flashes on the Tem-
perature indicator. It is possible to modify the
setting temperature only with flashed indicator.
To set a warmer temperature, press warmest
Temperature regulator . To set a colder temper-
ature, press coldest Temperature regulator. The
Temperature indicator displays the newly selec-
ted temperature for a few seconds and then
shows again the inside compartment tempera-
ture.
The newly selected-temperature must be
reached after 24 hours.
Caution!
During the stability period by the
first starting the temperature displayed can
not correspond to the setting temperature.
Temperature indicator
During normal functioning the Temperature in-
dicator shows the temperature inside the freez-
er.
4
www.zanussi.com
Summary of Contents for ZBB47460DA
Page 74: ...74 www zanussi com ...
Page 90: ...90 www zanussi com ...
Page 91: ...91 www zanussi com ...
