Turning forward the balance wheel and move thread take-up lever to the highest positon. Raise presser foot and insert the spool
into spoolholder (as shown in the illustration). Draw thread from the back side of the spool. (1) Lead the thread through the pre-
tension. (2) Hold the thread and pull it into the thread tension disc and then past the thread plate. (3) Pull up the thread tightly
and let it through the slit of thread take-up lever from the right side. (4) Then pull down thread and let it through the thread hook.
(5) Pull down thread and let it go through the catch the thread hook. (6) Pull thread through needle hole from the front to
the back.
Instruction: Cut the thread with sharp scissors so as to make easy threading.ln.
MACHINE THREADING
MACHINE THREADING
DRA
DRA
W UP
W UP
LOWER THREAD
LOWER THREAD
TENSION
TENSION
ADJUSTMENT OF UPPER THREAD
ADJUSTMENT OF UPPER THREAD
(1) Lift presser foot and hold the upper
thread lightly with your left hand.
(2) Keep turning forward the balance wheel until thread take-up Iever is at its
highest position.Pull the upper thread so as to pull up the lower thread.
(3) Leave about 5 cm of both threads
and pull them under the presser foot
then toward the back of the presser foot.
Leave 10 cm of both threads.
While doing straight stitching, both upper and lower threads must be knotted between the two layers of garment. Adjust selection
dial of thread tension disc within the window. (1) Regulated indicator (2) The smaller the tension of upper thread is bigger, turn up
the ındıcator. (3) The tension of upper thread ıs smaller, turn down the indicator.
The tension of upper thread in case of zigzag stitching.
In order to achieve good effect of zigzagging, the tension of upper thread should be less than that of straight stitching.
The upper thread should be visible from the reverse.
7
Anl.790.GB/SE/DK/FI/CZ/HU 13.09.2006 13:33 Uhr Seite 9