10
THE STRIPS OF LEG WIRE ON THE NEEDLE PLA
THE STRIPS OF LEG WIRE ON THE NEEDLE PLA
TE
TE
The Strips of leg wire on the needle plate is of great help to maintaining width between the needle and the thread.
Instruction: these data conforrn to the distance between strips of leg wire and the needle.
(1) Strips of leg wire (2) Comer (3) Needle plate (4) Hole of needle plate (5) The width of sewing to the center of needle
CHAPTER IV CLOTHES STITCHING
CHAPTER IV CLOTHES STITCHING Zigzag over-lock
(1) pattern selection dial:3), 3-5
(2) stitch length: 1 - 4
(3) presser foot: zigzag
(4) thread tension disc: 2-6
Simple zigzag stitches are often used for hemming.
Making button holes and elastic bends.
(1) pattern selection dial:3, 3-8
(2) stitch length: M1-2
(3) presser foot: zigzag
(4) thread tension disc:4-6
The stitch is used for making over-lock so that
thread at the edge of cloth shall not fall apart.
RIGHT
RIGHT
-ANGLE STITCH
-ANGLE STITCH
While doing right stitches, a space of 1.6 cm should bekept apart from the edge of
fabric When the edge of fabric is aligned with the corner. stop the machine and turn
(forward) the balance wheel to lower the needle. Raise the presser foot, turn the fabric
around the needle to change direction until its edge is aligned with the strip of leg
wire of 1.6 cm. Lower the presser foot and sew in the new direction.
(2) Thread from the corner
Figure on the needle plate
10
15
20
3/8
4/8
5/8
6/8
Spacing in cm
1.0
1.5
2.0
1.0
1.3
1.6
1.9
ZIGZAG STITCHING
ZIGZAG STITCHING
Anl.790.GB/SE/DK/FI/CZ/HU 13.09.2006 13:33 Uhr Seite 12
